Follow the same simple adhesion process used with the first panel. Line Panel 2 up next to panel 1,again ensuring it is level at the top and that the images on adjoining panels line up.Don’t worry about the excess - once your wall is completed you can cut this off using a sharp knife. Complete this process until you reach the bottom of your wall. If the bubbles are too big, gently lift off your wallpaper and re-apply. Smooth all bubbles and wrinkles out as you go. Once you are happy with the position, using your hand, gently smooth the wallpaper out with your hands. Peel 10cm of the backing paper from the back of your wallpaper, and stick it to the top of the wall.It is really important to get the position of the first panel correct as it will form the base of your wallpaper. If you need to overhang your first panel, don’t worry you can always trim the excess later. Please note, walls and doorways are not always perfectly square. Line your wallpaper up with the edge of the wall and the ceiling, making sure the wallpaper is level along the top. When installing your wallpaper, always start on the left-hand side of your wall with panel number 1.Ensure your wall is clean of lint, dust and dirt.Remember to remove any picture hooks - these can be returned after the wallpaper is hung.Not repairing damage can lead to poor wallpaper adhesion and possible damage when removing your wallpaper. Check your wall for cracks, holes and peeling paint.
Your wall should be smooth, properly primed, painted and cured wallboard/gyprock that has little or not surface variation.
The self-adhesive backing on all of Luxe Walls wallpaper allows for easy installation, with the ability to reposition your wallpaper to halt that horrible feeling when you aren’t happy with the wallpaper has been installed. Unlike traditional wallpaper, there is no need for messy glue, costly wallpaper installers or the need to steam for removal. Luxe Walls’ wallpapers are designed to be DIY.
0 kommentar(er)
